Note: Use an upholstery tool kit or similar when removing components.
Avoid scratching the body. Wear protective gloves.
1. Remove the front belt.
2. Remove the screws (A, B) and clip C holding the front wheel arch protector D.
Locations of fasteners
3. Carefully remove the front edge of the rear wheel arch A to release the hooks B.
4. Working from the bottom to the middle of the wheel arch, lift the wheel arch protector clamp part with a special tool to release the clips (C, D).
Note: Do not damage the painted part around the clip hole on the front fender when removing the clip. If you damage the painted part, repair it with touch-up paint to protect the area from corrosion.
5. Carefully pull out the rear edge of the rear wheel arch A to release the hooks B.
6. Working from the bottom to the middle of the wheel arch, lift the wheel arch protector clamp part with a special tool to release the clamps.
Note: Be careful not to damage the painted area around the clip holes on the front fender when removing the clips. If you damage the painted area, repair it with touch-up paint to protect the area from corrosion.
7. Perform the wheel arch protector installation operations in the reverse order of removal, observing the following: check the clamps for damage or whitening from the load and, if necessary, replace them with new ones.
Press firmly on the fasteners and fasteners to ensure a secure connection.
The article is based on information from the website: hondabook.ru