2. Installation is performed in the reverse order of removal. Replace damaged clamps.
[Publication reprinted from the website «HondaBook.ru»]
Replacing the rubber hood seal (Honda HR-V 1)
1. Using a clip remover, remove the clips, then remove the rubber hood seal.
2. Installation is performed in the reverse order of removal. Replace damaged clamps.
[Publication reprinted from the website «HondaBook.ru»]
2. Installation is performed in the reverse order of removal. Replace damaged clamps.
[Publication reprinted from the website «HondaBook.ru»]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits