Replacement
1. Disconnect the cable from the negative terminal of the battery.
Note: Before disconnecting the wire from the battery, make sure you know the access code for the radio. Otherwise, the radio will be blocked.
2. Remove the air filter housing (see chapter "Maintenance and general check and adjustment procedures").
3. Remove the battery, battery tray and battery bracket.
4. Loosen the bolt and remove the bracket (A) securing the automatic transmission fluid filter. Place the automatic transmission fluid filter (B) to the side.
- Tightening torque - 12 Nm
5. Disconnect the transmission input shaft speed sensor connector (A).
6. Remove the input shaft speed sensor (B) and O-ring (C).
- Tightening torque - 12 Nm
Note:
- Installation is carried out in the reverse order of removal.
- When installing, use only a new O-ring.
(Full version on the source website «Hondabook.ru»)