1. SEAL
2. Using a special tool, press the oil seal into the flywheel housing.
1. MANDREL HANDLE, 07749-0010000
2. FLYWHEEL CASE
3. MARKET, 32x35 mm, 07746-0010100
4. Depth after pressing: 2.5-3.5 mm
Flywheel housing input shaft seal — replacement (Honda HR-V 1)
1. Knock out the input shaft seal from the flywheel housing.
1. SEAL
2. Using a special tool, press the oil seal into the flywheel housing.
1. MANDREL HANDLE, 07749-0010000
2. FLYWHEEL CASE
3. MARKET, 32x35 mm, 07746-0010100
4. Depth after pressing: 2.5-3.5 mm
1. SEAL
2. Using a special tool, press the oil seal into the flywheel housing.
1. MANDREL HANDLE, 07749-0010000
2. FLYWHEEL CASE
3. MARKET, 32x35 mm, 07746-0010100
4. Depth after pressing: 2.5-3.5 mm
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits