Oil cooler (K20A, models without balance shaft block) (Honda Civic 7)

Replacement

1. Remove the oil filter.

2. Disconnect the bypass hose (A), unscrew the fitting (B) and remove the oil cooler (C).

3. Install the oil cooler with a new sealing ring (D). Tighten the fitting.

Tightening torque - 74 Nm

(The original text of the article is located on the website HondaBook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Lubrication system

Next ▶

Oil pump
Oil pan
Checking oil pressure
Oil pressure alarm sensor
Engine oil and filter

Oil injectors (K20A, models without balance shaft block)
Oil Catch Tank (D17A) — Installation

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)

General information
User manual
Maintenance
Power unit
Engines D15B and D17A
K20A Engines
Overhaul engine
Cooling system
Lubrication system
Fuel injection system
Toxicity reduction system
Engine electrical equipment
Transmission
Clutch
Manual gearbox
Automatic gearbox
Variator (CVT)
Drive shafts
Chassis and running gear
Car suspension
Steering
Brake system
Body and interior
Exterior (external elements)
Interior (internal elements)
Doors, locks and windows
Heater and air conditioner
Manual air conditioner
Automatic air conditioner
Security system
Electrical equipment
Equipment and devices
Headlights and lighting
Windscreen wipers
Audio system
Electrical diagrams