Oil Catch Tank (D17A) — Installation (Honda Civic 7)

Installation

1. Clean the contact surfaces of the oil separator.

2. Apply a layer of sealant to the contact surface of the oil catch can as shown in the figure.

Note: The parts must be installed within the time specified in the sealant application instructions. Otherwise, the sealant must be removed and reapplied.

Note: The parts must be installed within the time…

3. Install the oil catch can.

(Original material on the website: www.hondabook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Lubrication system

Next ▶

Oil injectors (K20A, models without balance shaft block)
Oil cooler (K20A, models without balance shaft block)
Oil pump
Oil pan
Checking oil pressure

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)

General information
User manual
Maintenance
Power unit
Engines D15B and D17A
K20A Engines
Overhaul engine
Cooling system
Lubrication system
Fuel injection system
Toxicity reduction system
Engine electrical equipment
Transmission
Clutch
Manual gearbox
Automatic gearbox
Variator (CVT)
Drive shafts
Chassis and running gear
Car suspension
Steering
Brake system
Body and interior
Exterior (external elements)
Interior (internal elements)
Doors, locks and windows
Heater and air conditioner
Manual air conditioner
Automatic air conditioner
Security system
Electrical equipment
Equipment and devices
Headlights and lighting
Windscreen wipers
Audio system
Electrical diagrams