Upper wishbone (Honda Civic 7)

Removal and installation

1. Jack up the rear of the vehicle and place it on stands.

2. Remove the rear wheels.

3. Disconnect the wheel speed sensor wire from the upper control arm.

4. Loosen the bolts and remove the upper wishbone.

2WD models.

4WD models.

Note:

Installation is carried out in the reverse order of removal.

After installation, check and, if necessary, adjust the rear wheel alignment angles.

(Publication reprinted from the website HONDABOOK)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Car suspension

Next ▶

Rear suspension anti-roll bar
Rear suspension strut
Rear Wheel Hub (4WD Models)
Rear Wheel Hub (2WD models with rear disc brakes)
Rear Wheel Hub (2WD models with rear drum brakes)

Trailing arm