Contents: Removal and installation ⇊ Examination ⇊
Removal and installation
1. Disconnect the connector (A) from the thermostat (B), disconnect the connector retainer (C) from the bracket. Loosen the screw and remove the thermostat.
2. Install in the reverse order of removal.
Examination
1. Connect the battery and lamp (3W - 18W) to the thermostat as shown in the figure.
2. Place the thermostat in cold water (less than 4 - 6°C) and make sure the lamp is not on.
3. Add hot water, make sure that when the temperature reaches more than 5 - 7°C, the lamp lights up.
[Full version on the source website Hondabook.ru]