Replacement
Oil filter made in Japan
Warning: After the engine has been running, the exhaust pipe will be hot. Be careful when working near the exhaust pipe. When the engine is hot, be careful when removing the drain plug. The oil temperature is very high and can cause burns.
1. Unscrew the oil filter with an oil filter wrench.
2. Inspect the threaded parts and rubber seal on the new filter. Wipe the engine block mounting area, then apply a thin layer of oil to the filter rubber seal,
Note: Use only filters with built-in bypass system.
3. Install the oil filter by hand.
4. After the rubber seal is seated, tighten the oil filter clockwise with the oil filter wrench.
Tightening: 7/8 turn clockwise
- Tightening torque: 22 Nm
Caution: Installation in a manner other than that specified above may result in serious engine damage due to oil leakage.
[You will find the original on the portal: www.HondaBook.ru]