Under severe operating conditions - every 10,000 km.
1. Remove the oil filter using an oil filter wrench.
2. Apply engine oil to the seal of the new oil filter.
Check the contact surfaces for dents or damage.
3. Tighten the oil filter by hand until the seal touches the contact surface.
4. After that, tighten the oil filter with the oil filter wrench to the required angle and torque.
- Required angle: 7/8 turn
- Tightening torque: 22 Nm (2.2 kg·m)
Attention:
- When tightening the oil filter to the specified angle or with the required force, be sure to use an oil filter wrench.
- If you do not use a special key and tighten the filter with a force that does not meet the requirements, you can damage the engine (oil leaks, etc.).
Method of tightening the filter to the required angle
When the seal contacts the contact surface, make a mark on the cylinder block under the number.
There are 8 numbers from 1 to 8 around the perimeter of the oil filter. Turn the filter clockwise by 7 numbers.
 |
 |
5. After tightening the filter, fill in the required amount of oil, start the engine, wait at least 3 minutes and make sure there are no oil leaks.
Full text available on the portal Hondabook.ru