Note. The parking brake cables must not be bent or damaged. This will lead to tight work of the cables and their premature failure.
If necessary, use the drawing of the hydraulic booster in disassembled state.
1. Fully release the parking brake lever.
2. Remove parking brake cable clamp A from cable B.
3. Disconnect the parking brake cable from lever C.
4. Remove the parking brake cable fasteners, then remove the cable.
5. Install the parking brake cable in the reverse order of removal. Pay attention to the following.
Attention! Be careful not to bend or damage the cable.
Make sure the parking brake cable clamp is fully seated on the cable sheath.
Adjust the parking brake.