2. On models equipped with rear drum brakes, remove the brake drum(s) (see Section Replacing the shoes of the rear wheel drum brake mechanisms).
3. Loosen the adjusting nut on the equalizer assembly (see Section Adjusting the parking brake). Disconnect the cable from the equalizer and remove the intermediate clamps from the cable sheath.
 |
 |
4. On models with rear drum brakes, remove the shoe assembly (see Section Replacing the shoes of the rear wheel drum brake mechanisms) and disconnect the parking brake drive cable from the actuator lever on the rear shoe. Press the locking tabs on the cable sheath holder and use pliers or a special 12 mm key to release the cable from the brake mechanism shield.
Note: If you don't have a special key at hand, you can use a small screw clamp.
 |
 |
5. On models with rear disc brakes, to disconnect the cable from the actuator lever, it is necessary to remove the clamp and remove the pin securing the split pin (see Section Replacing the shoes of the rear wheel drum brake mechanisms). The cable sheath is additionally secured in the bracket with a spring clamp.
6. Unbolt the brackets of the intermediate cable fastening clamps to the bottom of the car. Remove the cable, remembering its route.
Note: You may also need to remove the exhaust rear heat shield mounting bolts.
7. If necessary, remove the second drive cable in a similar manner.
8. Installation is carried out in the reverse order. Do not forget to adjust the parking brake drive.
(Full version on the source website: «HondaBook»)