2. Check the turn signal flasher relay according to Table 1 "Checking the turn signal flasher relay".
If a malfunction is detected, check the components listed in the "Possible Cause/Location of Malfunction" section of the table.
If the components are OK but the system does not work, replace the turn signal relay.
Table. Checking the turn signal relay (left hand drive models).
| Conclusion | Verification conditions | In good condition | Possible cause/location of malfunction |
| 1 | Constantly | Conductivity between terminal "1" and ground | - Poor ground contact (G501) - Broken wire |
| 3 | Ignition switch in the "ON" (II) position, hazard warning switch in the "OFF" position | At terminal "3" the battery voltage | -Fuse No.19 (7.5 A) (mounting block in the cabin) - Hazard warning switch - Broken wire |
| Ignition switch in the "OFF" position, hazard warning switch in the "ON" position | At terminal "3" the battery voltage | -Fuse No.5 (10A) (mounting block in the engine compartment) - Hazard warning switch - Broken wire | |
| 2-3 | Terminals "2" and "3" are closed, the emergency signal switch is in the "ON" position | All direction indicators are on | -Fuse No.5 (10A) (mounting block in the engine compartment) - Hazard warning switch - Turn signal lamp - Bad ground connection (G201, G301, G501, G601), - Wire break |
Location of hazard warning system components (sedan).1 - direction indicator lights, 2 - lighting control switch, 3 - direction indicator flasher relay, 4 - mounting block in the passenger compartment, 5 - hazard warning light switch.
Location of hazard warning lights components (hatchback). 1 - direction indicator lights, 2 - lighting control switch, 3 - direction indicator flasher relay, 4 - mounting block in the passenger compartment, 5 - hazard warning light switch.
[The article is based on information from the website www.hondabook.ru]