Removal and installation turn signal repeaters (Honda Civic 7)

Caution: Be careful not to damage the wing.

1. Press the turn signal repeater (B) at the location indicated by the arrow in the figure and remove it.

2. Disconnect the connector (A) and remove the socket and lamp.

Turn signal repeater lamp - 5W

3. Install in the reverse order of removal.

(Based on materials from the website: HondaBook)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 7: Headlights and lighting

Next ▶

Replacing fog light bulbs (models produced since 9/2003)
Adjusting the fog lights (models produced since 9/2003)
Removal and installation fog lights (models produced since 9/2003)
Checking the headlight mode switching electromagnet
Removal and installation the headlight mode switching electromagnet

Removal and installation the rear combination light
Removal and installation an additional brake light
Removal and installation the license plate light bulb
Checking the brake light switch
Hazard warning lights — turn signal relay check

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)