Input signal test (KS model)
This area contains SRS components. Before performing repairs and maintenance, review the SRS component locations, precautions, and procedures in the SRS section.
1. Remove the lower instrument panel cover on the driver's side.
2. Disconnect the 10K connector from the integrated control unit.
3. Remove the integrated control unit from the under-panel fuse/relay box.
4. Inspect the connectors and socket contacts to ensure that they are in good contact.
- If the contacts are bent, loose or corroded, correct them and retest the system.
- If the contacts are OK, perform the following tests for input signal at the fuse/relay box connector and socket.
- If any of the tests identify a problem, find and correct the cause, then test the system again.
- If all input signal tests are positive, the integrated control unit is faulty, replace.
All systems:
Intermittent wiper control system:
Headlight warning system (except for KY model):
Rear fog light control system:
Seat Belt/Key in Lock Reminder System:
Incandescent lamp testing system (brake system lamp) (model KQ):
[You will find the original on the portal HondaBook.ru]