Replacement
Side turn signal light:
1. Press the retaining spring and remove the side turn signal lamp.
2. Disconnect the 2K connector from the flashlight.
Number plate light:
1. Remove the two screws from the license plate light bulb and pull the bulb out halfway.
2. Disconnect the 2K connector from the lamp.
3. Remove the lens, then replace the bulb.
Checking the input signal of the hazard/turn signal relay
This area contains SRS components. Before performing repairs and maintenance, review the SRS component locations, precautions, and procedures in the SRS section.
1. Remove the hazard warning/turn signal relay from the under-panel fuse/relay box.
2. Inspect the relays and the contacts of the fuse and relay box sockets to ensure that they are securely connected.
- If the contacts are bent, loose or corroded, repair them if necessary and retest the system.
- If the contacts are OK, perform the following tests for the input signal to the fuse and relay box socket.
- If any of the tests reveal a problem, find and correct the cause, then test the system again.
- If all input signal tests are positive, the hazard/turn signal relay is faulty, replace it.
(Full version on the source website: hondabook)