Replacement
1. Remove the sunlight sensor from the dashboard and disconnect the 2K connector.
Note: Be careful not to damage the panel.
2. The installation order is the reverse of the removal order.
Trial
Turn on the ignition (ON (ll). Measure voltage: probe (+) to contact No. 1, probe (-) to pin No. 2 of the 2K connector. The voltage should be:
- 3.7±0.2V or more when the sensor is out of direct sunlight.
- 3.6±0.2V or less when the sensor is under direct light.
Note: Voltage will not change under artificial light or fluorescent light