2. Use a screwdriver to pry up the horn cover emblem.
3. Mark the relative position of the wheel hub and steering shaft and unscrew the mounting nut.
Fig. 24.3 Steering wheel assembly:
1 - sound signal wire;
2 - sliding ring;
3 - back cover;
4 - spring;
5 - contact board;
6 - emblem.
4. Pull the steering wheel off the shaft. A puller is usually not required.
5. Installation is performed in the reverse order of removal. Install the wheel relative to the shaft using the marks made earlier.
6. Connect the cable to the negative battery terminal.