Removal/Installing Accelerator Pedal Module (L13A) (Honda Civic 8)

1. Disconnect the accelerator pedal module A connector.

2. Using a flat-blade screwdriver A, push the retaining plate B, then remove the accelerator pedal module C.

Note: The APP sensor is not supplied as a spare part. Do not disassemble the accelerator pedal module.

3. Install the accelerator pedal module in the reverse order of removal.

[The original is located on the website hondabook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 8: Injection system (gasoline)

Next ▶

Electronic throttle control system
I-DSI fuel system
PGM-FI fuel system
Fuel injection system components

Checking the APP sensor signal (L13A)
Fuel supply system
Checking fuel pressure (L13A)
Checking the suction pipe and fuel vent line (L13A)
Replacing the fuel filter (L13A)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)