Driver's door
1. Remove the driver's door trim panel.
2. Disconnect the connector (A).
3. Check the operation of the window lift by applying battery voltage to terminals "1" and "2".
| Conclusions | Electric drive | |
| 1 | 2 | |
| + | - | UP |
| - | + | DOWN |
4. Connect the connector (A).
5. Measure the voltage between the terminals during operation of the electric drive according to the table.
| Conclusions | Voltage | |
| + | - | |
| 6 | 4 | Battery voltage |
| 3 | 4 | Ripple 0 ＜ — ＞ more than 3V (1 pulse - 1 revolution) |
| 5 | 6 | |
If operation is not as described, replace the driver's door window motor.
Front passenger door, rear side doors
1. Remove the door trim panel.
2. Disconnect the connector (A).
3. Check the operation of the window lift by applying battery voltage to terminals "1" and "2".
| Conclusions | Electric drive | |
| 1 | 2 | |
| + | - | UP |
| - | + | DOWN |
(Material obtained from the website: hondabook)