Note: When installing a new belt, first adjust the sag or tension to the new belt value, then adjust the sag or tension to the used belt value by starting the engine and letting it run for 5 minutes.
Sag:
- Used belt: 8.0-10.5 mm
- New belt: 6.0-8.5mm
Note: If the belt is worn or damaged, replace it.
Method of measuring deflection
Apply a force of 98 Nm (10 kgf) and measure the deflection between the generator and crankshaft pulleys.
Method of measuring belt tension using a dynamometer
Attach the dynamometer to the belt and measure the tension. Follow the dynamometer manufacturer's instructions.
Tension:
- Used belt: 340-490 N (35-50 kgf)
- New belt: 540-740 N(55-75 kgf)
Note: If the belt is worn or damaged, replace it.
If adjustment is required:
1. Loosen the mounting nut and lock nut.
2. Move the generator and adjust the belt tension to the required value, then tighten the nuts.
3. Recheck the belt deflection or tension.
Note: For adjustment of the power steering pump and air conditioning compressor drive belts, refer to the relevant chapters.
The original is located on the website: hondabook.ru