Checking the rear side door lock drive with electric drives (Honda Avancier 1)

1. Remove the door trim (see chapter Body) and disconnect the 2-pin connector from the lock actuator.

2. Apply battery voltage to the terminals as shown below and check that the rod moves to LOCK and UNLOCK side.

Caution: When applying voltage from the battery to the drive, briefly connect the wire to the (-) terminal of the battery. If voltage is applied for a long time, the drive may be damaged.

(You will find the original on the portal «HondaBook.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Equipment and devices

Next ▶

Checking door lock drives with electric drives
Door locks with electric drives — transmitter registration
Door locks with electric drives — transmitter check
Door locks with electric drives — checking the input signals of the remote…
Door locks with electric drives — electrical diagram

Checking the driver's door lock cylinder switch
Checking the switch of the locking lever of the driver's door with electric…
Checking the driver's door lock switch with electric drives
Audio system — component layout
Audio system wiring diagram (models with Premium audio system)