Adjustment
1. Adjust the position of the trunk lid if necessary.
a) To adjust the position of the trunk lid, loosen the hinge mounting bolts as shown in the figure "Adjusting the trunk lid".
b) Tighten the bolts after adjustment.
Tightening torque - 10 Nm
2. If necessary, adjust the position of the trunk lid lock bracket.
a) Loosen the trunk lid lock bracket mounting bolts.
b) Adjust the position of the bracket by tapping it with a plastic-headed hammer.
c) Tighten the bolts after adjustment.
Tightening torque - 10 Nm
Removal and installation the torsion bar
1. Disconnect the torsion bar from the center clamp as shown in the figure.
2. Using a special tool, disconnect the torsion bar first from the right hinge of the trunk lid, then from the left.
Adjusting the trunk lid.
3. Disconnect the central retainer from the body.
4. Installation is carried out in the reverse order of removal.
Removal and installation the trunk lid seal
1. Remove the trunk lid seal.
2. Place a timing mark on the seal. Align the mark with the pin at the top of the trunk opening as shown in the figure and install the seal.
3. Check the tightness of the seal.
