Checking the hazard warning switch (Honda Civic 8)

1. Remove the center panel.

2. Remove the two mounting screws, then remove the hazard warning switch from the rear of the panel.

3. Check the continuity of the connection between the terminals in each switch position according to the table.

4. Remove cover A, then remove lamp B.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Yaroslav Shiryaev

◀ Previous

Civic 8: Headlights and lighting

Next ▶

Replacing the rear lights and tailgate light
Checking the backlight switch (R18A)
Replacing front fog light bulbs
Adjusting the front fog lights
Checking and replacing the combination light switch

Checking the Turn Signal and Hazard Warning Light Inputs (MICU)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Civic 8 (2005-2011)

Civic 7 (2000-2005)

General information
User manual
Maintenance
Power unit
Engines D15B and D17A
K20A Engines
Overhaul engine
Cooling system
Lubrication system
Fuel injection system
Toxicity reduction system
Engine electrical equipment
Transmission
Clutch
Manual gearbox
Automatic gearbox
Variator (CVT)
Drive shafts
Chassis and running gear
Car suspension
Steering
Brake system
Body and interior
Exterior (external elements)
Interior (internal elements)
Doors, locks and windows
Heater and air conditioner
Manual air conditioner
Automatic air conditioner
Security system
Electrical equipment
Equipment and devices
Headlights and lighting
Windscreen wipers
Audio system
Electrical diagrams