Vehicle lighting system Honda HR-V 1

General description of the lighting system
Note: Left hand drive model shown; the layout on the right-hand drive model is similar. 1. COMBINATION LIGHTING SWITCH 2. HIGH BEAM SIGNAL LAMP 3. REAR FOG LAMP CONTROL UNIT (KG and KE models) 4. REAR FOG LIGHT SWITCH...

Testing and replacing the combination light switch
1. Remove the steering column covers (see chap. " Steering "). 2. Disconnect the 16-pin connector from the combination light switch. 3. Remove the two screws, then take out the combination light switch. 4. Check the...

Headlights — replacement and adjustment
Replacement Warning! Headlights with halogen lamps become very hot during operation; do not touch them or their mounting hardware immediately after they have been disconnected. Do not attempt to replace or clean...

Side turn signal lights
Replacement 1. Press the retaining spring and remove the side turn signal lamp. 2. Remove the lamp holder from the left housing and replace the bulb. 1. light bulb (5W); 2. mounting spring; 3. protective fabric

Rear lights — replacement
1. Open the back door. 2. Remove the two mounting bolts from the taillight assembly. 3. Carefully remove the taillight assembly from the body. 1. FASTENING BOLTS 2. REAR LIGHTS ASSEMBLY REAR FOG LAMP: 21W TURN SIGNAL...

Number Plate Lights — Replacement
1. Remove the rear door trim panel (see chap. " Body "). 2. Remove the bulb holder. 1. DIFFUSER 2. LIGHT BULB SOCKET 3. 2-PIN CONNECTOR 4. LIGHT BULB (5W)

Rear fog lights (models KG and KE)
Testing the signal at the control unit input 1. Disconnect the 5-pin connector from the rear fog light control unit. 2. Check the contacts of the connector and the socket and make sure that they provide reliable contact...

Electric headlight corrector (models KG and KE)
Testing the headlight range control switch 1. Remove the switch panel from the instrument panel. 2. Disconnect the 5-pin connector from the switch. 3. Press the switch from behind the panel and remove it. 1. 5-PIN...

Instrument cluster light dimmer (model KQ)
Testing the signal at the controller input Note: The control unit is built into the instrument panel light controller. 1. Remove the switch panel from the instrument panel. 2. Disconnect the 3-pin connector from the...

High Brake Light Replacement
1. Remove the cover from the flashlight. 2. Unscrew the two ET screws, then remove the light from the body. 3. Disconnect the 2-pin connector from the bulb socket. 1. SCREW! 2. HIGH STOP LIGHT 3. COVER 4. LIGHT BULB (21...

Turn signal and hazard warning lights
Note: Left hand drive model shown; the layout on the right-hand drive model is similar. 1. EMERGENCY WARNING LAMP 2. TURN SIGNAL LAMPS 3. EMERGENCY ALARM SWITCH 4. COMBINATION LIGHT/TURN SIGNAL SWITCH 5. TURN...

Interior Lighting — Description and Testing
Note: The illustration shows a left-hand drive model; the layout on the right-hand drive model is similar. 1. FRONT CEILING LIGHT 2. PASSENGER DOOR SWITCH 3. REAR CEILING LIGHT 4. REAR DOOR LOCK SWITCH 5. LUGGAGE...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code