Car engine lubrication system Honda CR-V 2

Engine lubrication system
Component arrangement

Testing the oil pressure sensor
1. Disconnect the yellow wire with the red stripe (A) from the engine oil pressure sensor (B). 2. Check for continuity between the positive terminal (C) and the engine (ground). There should be continuity when the...

Oil pressure testing
If the oil pressure warning light remains on while the engine is running, check the engine oil level. If the oil level is normal: 1. Connect a tachometer or Honda PGM tester. 2. Unscrew the oil pressure sensor and...

Engine oil change
1. Warm up the engine. 2. Remove the drain bolt (A) and drain the engine oil. 3. Tighten the drain bolt, installing a new washer (B), 4. Fill the engine with the recommended oil. Filling capacity When changing oil...

Replacing the oil filter (Japanese oil filter (3/4 turn))
1. Unscrew the oil filter with a special key. 2. Check the condition of the threads (A) and rubber seal (B) on the new filter. Wipe the seat on the cylinder block, then apply a thin layer of oil to the rubber filter...

Oil filter replacement (Japanese oil filter (7/8 turn))
1. Unscrew the oil filter with a special key. 2. Check the condition of the threads (A) and rubber seal (B) on the new filter. Wipe the seat on the cylinder block, then apply a thin layer of oil to the rubber filter...

Replacing the oil filter (French oil filter (3/4 turn))
1. Unscrew the oil filter with a special key available on the market (LABINAL-Purflux 76). 2. Check the condition of the threads (A) and rubber seal (B) on the new filter. Wipe the seat on the cylinder block, then apply...

Replacing the oil filter holder
1. Unscrew the oil filter. 2. Unscrew the oil filter holder. 3. Screw in the new oil filter holder and tighten to 49 Nm (5.0 kgf·m).

Oil pump
Assembly drawing

Removal the oil pump
1. Set the piston of cylinder No. 1 to TDC. 2. Remove the oil pan. 3. Remove the oil pump drive chain tensioner. 4. Secure the rear balance shaft by inserting a punch into the hole in the rear balance shaft through the...

Checking the oil pump
1. Remove the pump housing. 2. Check the radial clearance between the inner (A) and outer (B) gears of the oil pump. If the clearance exceeds the wear limit, replace the oil pump. Radial clearance between internal and...

Checking the balancing shafts
1. Place the balance shaft in place by sliding it away from the oil pump sprocket. 2. Set the indicator to zero by resting it against the end of the balance shaft, then move the balance shaft in the forward and reverse...

Installing an oil pump
1. Make sure that the piston of cylinder No. 1 is at TDC. 2. Align the alignment pin (A) on the rear balance shaft with the mark (B) on the oil pump. 3. Secure the rear balance shaft by inserting a punch into the hole...

Replacing the oil pressure sensor
1. Disconnect the connector from the oil pressure sensor, then unscrew the sensor. 2. Apply sealant to the threads of the oil pressure sensor, then screw in the sensor.

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code