1. Using tape, mark the position of the windshield wipers on the windshield of the car. Loosen the nuts securing the windshield wiper arms (rods) (see accompanying illustration). Remove the leashes.
2. Remove the central part of the plastic fastening clips of the upper edge of the fairing, then release the fasteners themselves (see accompanying illustration).
3. Carefully remove the clamps securing the lower edge of the fairing (see illustration for paragraph 2). Remove the fairing panel from the vehicle.
Note: Pry the panel just below the clips, being careful not to tear the hood seal.
4. Installation is carried out in the reverse order. Do not forget to set the windshield wipers in accordance with the marks applied during dismantling.