1. ADJUSTABLE BEARING PULLER, 07JAC-PH80000
2. CLUTCH CASE
2. Remove the oil seal from the clutch housing (figure in the right column above).
1. SEAL
2. CLUTCH CASE
3. Using a special tool, press in a new oil seal from the gearbox side as shown in the figure.
1. CLUTCH CASE
2. MANDREL HANDLE, 07749-0010000
3. SEAL. Replace
4. MARKET, 42x47 mm, 07746-0010300
4. Using the special tool, press in the new ball bearing from the gearbox side as shown in the figure.
1. CLUTCH CASE
2. MANDREL HANDLE, 07749-0010000
3. BALL BEARING
4. MARKET, 62x68 mm, 07746-0010500
[Material obtained from the website: HONDABOOK]