Note: Air must be bled from the fuel after disassembling the fuel system for maintenance, or after the tank runs out of fuel. For information on how to perform this procedure, see here.
1. Fill the tank with fuel.
2. Remove cover A.
3. Squeeze the fuel priming handle A and press it 40-50 times. Press the fuel priming handle until you feel resistance.
4. Stop pumping the fuel system when you feel resistance from the handle and start the engine.
5. Accelerate the engine about 3 times, then check the stability of the engine idle speed.
6. If the engine does not start, press the handle again until you feel resistance.
Note: Please note that the continuous cranking time of the engine should not exceed 30 seconds at a time. If the engine cranking process lasts more than 30 seconds, it may cause damage to the starter and fuel pump.
(Original published on this resource: «www.hondabook.ru»)