Removal and installation
1. Remove the refrigerant from the system.
2. Remove the front bumper (see chapter "Body").
3. Loosen the bolts and disconnect the outlet pipe (A) and inlet pipe (B) from the condenser.
Note: To avoid contamination of the system, immediately install plugs on open ends of pipes.
4. Loosen the bolts and remove the condenser (A) by lifting it upwards.
Caution: Do not damage the condenser and radiator plates when removing and installing the condenser.
5. Install in the reverse order of removal.
Note:
- When installing a new capacitor, add 25 ml of compressor oil.
- Before installing new O-rings, lubricate them with compressor oil.
- After using compressor oil, seal the oil container tightly to prevent moisture from entering.
- Do not allow compressor oil to come into contact with painted surfaces of the vehicle, as this may damage the paintwork. If compressor oil comes into contact with a painted surface, remove it immediately.
6. Evacuate the system.
7. Charge the system.
8. Check the efficiency of the refrigerant circulation system.