Automatically controlled heater and air conditioner (Honda HR-V 1)

Contents: Usual method of application ⇊ Manual control ⇊ Blowing mode button ⇊ Removal fog or ice from the…⇊ Quick removal of fog ⇊ When constant use of air…⇊

Usual method of application

1. Press the AUTO button.

2. The required temperature in the cabin is set and displayed on the indicator.

To turn off the air conditioner, press the OFF button.

Note:

To prevent cold outside air from entering, the fan may not operate for a while after the air conditioner is turned on.

After setting the desired temperature, do not turn the control knob. Otherwise, the time to reach the set temperature may increase.

Manual control

Each button can be used in combination with others. Even when working in automatic mode (FULL AUTO), pressing the buttons works. Despite the fact that the "FULL" indicator goes out, except for the changed function of the pressed button, the rest are performed automatically. To return to the "FULL AUTO" mode, you must press the "ACTO" button again.

Blowing mode button

Removal fog or ice from the windshield or side windows

Press the defroster button.

When you press the button, the air conditioner automatically turns on and switches to the outside air supply. In addition, the air flow to the windshield and side windows is switched.

Note: When turning on the defroster, do not set the temperature near the lower limit. If cold air hits the glass, ice may form on the outside of the glass and visibility will be impaired.

Quick removal of fog

If you supply air from the passenger compartment for a long time, the windows will fog up due to the moist air exhaled by people in the passenger compartment. After drying the windows once, switch to taking in outside air.

When constant use of air conditioning is not required

During periods when the air conditioner is not used for a long time, it is necessary to periodically turn it on for a few minutes to lubricate the compressor.

The automatic air conditioner is equipped with temperature and sunlight sensors. Do not place objects on the sensor locations, and also make sure that they are not exposed to water.