When removing components, use an upholstery tool kit or similar.
When installing/removing the front bumper, be careful not to scratch the front bumper itself and the car body. Wear protective gloves.
1. Remove the front belt.
2. Remove bolts A and fasteners B holding the front bumper C.
3. Unscrew screws A and detach clips B on both sides.
4. Carefully remove the front edge of the rear wheel arch A to release the hooks B.
5. Working from the bottom to the middle of the wheel arch, lift the wheel arch protector clamp part with a special tool to release the clips (C, D).
Note: Do not damage the painted part around the clip hole on the front fender when removing the clip. If you damage the painted part, repair it with touch-up paint to protect the area from corrosion.
 |
 |
6. Repeat steps 4 through 5 on the other side of the front bumper to release the front wheel arch protector from the front bumper.
7. Insert technical napkin A between the wheel arch protectors B and the body on both sides. Unscrew the front bumper mounting screws C on both sides.
8. Pull the front bumper A near the wheel arches to remove it from the hooks B and side retainers C.
9. While removing the section of the bumper next to the wheel arch from the side retainer A, with the help of an assistant, pull the front bumper to remove it from the hooks B located on the upper corner beam C.
10. With the help of an assistant, pull the rear bumper A to remove it from the hooks B located on the bracket C of the front bumper and, if equipped, disconnect the connectors D of the front fog lights.
11. For some models: When securing the retaining plate E, pull the headlight washer pipe F to disconnect it from the headlight washer actuator socket G.
12. Install the rear bumper in the reverse order of removal. Please note the following:
If the vehicle is equipped with fog lights and headlight washers, be sure to connect the fog light connectors and connect the headlight washer line.
Make sure the front bumper is fully engaged with the hooks (located on the side beams and clamps) on both sides of the car.
Check the clamps for damage or whitening from stress and replace them with new ones if necessary.
Press firmly on the fasteners and fasteners to ensure a secure connection.
(The original can be found on the resource HondaBook.ru)