2. Turn off the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced.
3. Place the jack only in the places specially designated for it, as shown in the figure.
Models with spoiler.
Models without spoiler.
Attention:
- Install the jack only in the recommended position. If the jack is installed incorrectly, it may cause dents in the car body or the jack may fall, injuring you.
- Avoid installing the jack on a slope or unstable surface. Otherwise, the jack may tilt and move from the installation position or fall, which may cause an accident. Always install the jack on a flat, hard surface.
- Before installing the jack, make sure that there is no sand or small stones on the supporting surface.
4. Install the jack handle as shown in the figure.
5. Turn the handle to the right to jack up the car.
6. After completing the work, lower the car and fold the jack.
The text can be found on the website: hondabook.ru