2. Remove the plug (A) from the filler hole and remove the sealing washer, then check the condition and level (C) of the fluid.
3. The liquid level should reach the lower edge of the filler hole. If it is lower, add the recommended type of fluid until it starts to flow out of the hole, then screw the plug into the filler hole, installing a new sealing washer.
4. If the differential fluid is dirty, remove the drain plug (A) and drain the fluid.
5. Clean the drain plug, install a new sealing washer on it and fill the differential with the recommended type of fluid to the required level.
Note: If the differential is disassembled, check the fluid level again after completing the 4WD system check. Add fluid if necessary.
Liquid filling volume:
1.0 l when changing the fluid
1.2 l during repair
Recommended fluid: Honda DPSF (Dual Pump System Fluid)
6. Screw the plug into the filler hole, installing a new sealing washer.
[Based on materials from the website: Hondabook.ru]