Electrical equipment of the car engine Honda CR-V 2

Engine starting system
Component arrangement Troubleshooting the Starter Circuit Note: During this procedure, the ambient temperature should be between 15 - 38°C. After performing this test or subsequent repair, reset the engine control...

Starter replacement
1. Disconnect the negative cable from the battery, then the positive cable. 2. Disconnect the knock sensor connector. 3. Unscrew the bolt securing the wiring bracket. 4. Disconnect the starter cable (A) from terminal B...

Starter repair
Disassembly/assembly Rotor inspection and testing 1. Remove the starter. 2. Disassemble the starter as described at the beginning of this procedure. 3. Check the rotor for wear or damage due to contact with the...

Ignition system
Component arrangement Checking the ignition timing angle 1. Start the engine. Maintain the engine speed at about 3000 rpm (min⁻¹) with no electrical load, with the selector lever in position P or N, until the radiator...

Ignition coils, spark plugs
Removal/installing ignition coils 1. Remove the ignition coil cover (A), then remove the ignition coils (B). 2. Installation of ignition coils is performed in the reverse order of removal. Troubleshooting Ignition Coils...

Charging system
Component arrangement Troubleshooting the charging system If the charging system indicator does not come on or go out, or the battery is discharged, test the following components in the order listed: Battery Charging...

Generator belt
Checking the drive belt Make sure the automatic tensioner indicator (A) is within the standard range (B) as shown. Otherwise, replace the drive belt. Replacing the drive belt 1. Remove the mud deflector. 2. Slide the...

Car Generator
Generator replacement 1. Disconnect the cable from the negative battery terminal, then from the positive one. 2. Remove the bolt (A) securing the battery retainer, then remove the partition cover (B). 3. Remove the...

Cruise control
Component arrangement Electrical diagram Troubleshooting Note: The numbers in the table indicate the sequence of troubleshooting. Before search behavior: Check fuses #10 (7.5A) and #4 (10A) in the under-dash fuse/relay...

Testing the signal at the input of the cruise control unit
Components of the optional Inflatable Airbag System (SRS) are located on this site. Before performing any repair or maintenance work, review the location of the SRS components and the precautions to be taken when...

Testing of cruise control units and mechanisms
Testing/replacing the main switch 1. Separate the three clips (A) and create a gap between the bulkhead and the instrument panel. 2. Release the main switch clamps and push the main switch (B) out of the panel, then...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Link in different formats to this section

TEXTHTMLBB Code