Checking wheel runout (Honda CR-V 2)

1. Raise the vehicle and support it securely.

2. Make sure the wheels are not bent or deformed.

3. Fix the indicator as shown in the figure and measure the axial runout by rotating the wheel.

Axial runout of front and rear wheels

Standard	Cast disk	0-0.7 mm
	Stamped disc	0-1.0 mm
Limit		2.0 mm

4. Reinstall the indicator as shown in the figure and measure the axial runout by rotating the wheel.

Radial runout of front and rear wheels

Standard	Cast disk	0-0.7 mm
	Stamped disc	0-1.0 mm
Limit		1.5 mm

5. If the wheel runout is abnormal, check the bearing axial play and make sure that the contact surfaces of the brake disc and wheel are clean on the inside.

6. If the bearing axial clearance is within the normal range, but the wheel runout exceeds the specified limit, replace the wheel.

[The article was taken from the website «hondabook.ru»]