2. Remove the cover from the partition.
3. Remove the mud deflector.
4. Remove the radiator cap.
5. Loosen the drain plug (A) and drain the coolant.
6. Loosen the tank mounting bolt (A) and remove the tank.
7. Remove the coolant pipe from the radiator, then lower the end of the coolant pipe below the reservoir and drain the coolant into the reservoir.
8. After the coolant has drained, tighten the radiator drain plug and reinstall the coolant pipe and reservoir.
9. Install the dirt deflector.
10. Install the cover on the partition.
11. Fill the reservoir to the MAX mark (A) with genuine Honda AH Season Antifreeze/Coolant Type 2 fluid.
12. Pour genuine Honda All Season Antifreeze/Coolant Type 2 into the radiator to the base of the filler neck.
Note:
- Use only Honda All Season Antifreeze/Coolant Type 2 branded liquid. Using a coolant that is not manufactured by Honda may cause corrosion and cause the cooling system to fail or fail.
- Honda AH Season Antifreeze/Coolant Type 2 is a mixture of 50% antifreeze and 50% water. No pre-mixing is required.
Engine cooling system capacity (including 0.55 l tank):
Engines K20A4, K20A5:
- Manual transmission: 5.4 l
- Automatic transmission: 5.3 l
Engine K24A1:
- Manual transmission: 5.5 l
- Automatic transmission: 5.4 l
13. Place the cap on the radiator, but do not tighten it.
14. Start the engine and allow it to warm up to normal operating temperature (the radiator fan will start working at least twice).
15. Turn off the engine. Check the radiator level and top up with Honda All Season Antifreeze/Coolant Type 2 if necessary.
16. Tighten the radiator cap securely, then start the engine again and check for leaks.
(The article was taken from the website HONDABOOK.ru)