2. Turn the water pump counterclockwise. Make sure it rotates without binding.
3. Check for signs of leakage through the seal. A slight leak from the bleed nipple (A) is considered normal.
Checking the water pump (Honda CR-V 2)
1. Remove the drive belt.
2. Turn the water pump counterclockwise. Make sure it rotates without binding.
3. Check for signs of leakage through the seal. A slight leak from the bleed nipple (A) is considered normal.
2. Turn the water pump counterclockwise. Make sure it rotates without binding.
3. Check for signs of leakage through the seal. A slight leak from the bleed nipple (A) is considered normal.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Mikhail Kopasov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Technical data
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Exhaust system
- Fuel system
- Engine management
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Rear differential
- Drive shafts
- Chassis and running gear
- Steering
- Front suspension
- Rear suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- General information
- Maintenance
- Tips for car owner
- Power unit
- Engine repair
- Engine overhaul
- Cooling and lubrication system
- Engine electrical equipment
- Control system
- Fuel system
- Transmission
- Clutch and drive shafts
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Body service
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits