Warning!
Frequent inhalation of dust from brake pad surfaces, regardless of the material composition, can pose a health hazard.
- Do not inhale dust.
- Do not clean brake surfaces with compressed air or a brush. Use a vacuum cleaner.
15-inch brake disc (AD57-15)
14-inch brake disc (AD57-14)
Carry out removal, disassembly, inspection, assembly and installation of the caliper taking into account the following:;
- Do not spill brake fluid on your car as it may damage the paintwork; if liquid does spill, wash it off immediately with water.
- To prevent liquid from spilling, cover the hose joints with rags or napkins.
- Clean all components in brake fluid and dry in open air; blow out all channels with compressed air.
- Before assembly, make sure that the components are free of dust and other foreign particles.
- Replace parts with new ones when instructed to do so.
- Do not allow dirt or other foreign material to enter the brake fluid.
- When reusing brake pads, always install them in their original position to avoid loss of braking efficiency.
- Do not reuse drained brake fluid.
- Always use Genuine Honda DOT3 brake fluid. Using other fluids may cause corrosion and reduce the life of the brake system.
- Do not mix brake fluid of different brands, as they may be incompatible.
- Apply clean brake fluid to the piston, into the piston seal groove and to the piston cylinder walls.
- Make sure there is no grease or oil on the brake discs or pads.
- In case of disassembly, replace all rubber parts with new ones.
- After installing the front brake caliper, check for leaks at the hose and tube joints or fittings, and check that the brake hoses are not interfering or twisted.
(Material obtained from the website: «HondaBook.ru»)