CR-V and 4-cylinder Odyssey
Withdrawal
1. Designate and disconnect high-voltage wires from candles.
2. Remove the bolts (starting with the bolts around the periphery of the cover and moving towards the center).
3. Remove all brackets and clamps from the cover, disconnect the hoses.
4. Remove the cylinder head cover (it is recommended to remove the seals first). If necessary, pry off the cover at the corners, shifting no more than 1 mm.
Installation
5. Clean the split planes of the cover and cylinder head.
6. Check the condition of the gasket and cover seals. If there are no cracks or signs of aging on the gasket and seals, they can be installed after rinsing thoroughly in alcohol.
7. Install the seals in the cover, lubricating them with Honda sealant 08718-0001 or 08718-0003. Place the gasket into the groove of the cover.
8. Install the cover by applying sealant to the corners of the gasket with a 6 mm diameter roller. Tighten the bolts evenly to 9.8 Nm. Install all removed parts.
Odyssey V6
Withdrawal
1. Remove the suction manifold.
2. Designate and disconnect wires from coils of ignition and remove coils.
3. Remove the bolts (starting with the bolts around the periphery of the cover and moving towards the center).
4. Remove a cover of a head of cylinders, having followed safety of sealants. If necessary, pry off the cover at the corners, shifting no more than 1 mm.
Installation
5. Clean the split planes of the cover and cylinder head.
6. Check the condition of the gasket and cover seals. If there are no cracks or signs of aging on the gasket and seals, they can be installed after rinsing thoroughly in alcohol.
7. Install the seals in the cover, lubricating them with Honda sealant 08718-0001 or 08718-0003. Place the gasket into the groove of the cover.
8. Install the cover by applying sealant to the corners of the gasket with a 6 mm diameter roller. Tighten the bolts evenly to 9.8 Nm. Install all removed parts. Replace the intake manifold gasket.