Ignition Coil — Checking and Replacing (Honda CR-V 1)

Contents: Examination ⇊ Removal and installation ⇊

Examination

1. Disconnect the battery from ground and remove the distributor cap and gasket.

2. On some vehicles, loosen the locking screw, remove the runner and dust cover.

3. Check the resistance of the primary winding. To do this, disconnect the black/yellow wire from terminal A (+) and the white/blue wire from terminal B (-). The resistance between the terminals of the primary winding should be 0.63-0.77 Ohm (CR-V) and 0.4-0.6 Ohm (4-cylinder Odyssey).

4. Check the resistance of the secondary winding, which is measured between terminal A (+) and the high-voltage terminal. Resistance should be 12.8-19.2 kOhm (CR-V) and 22.4-33.6 kOhm (4-cylinder Odyssey).

Removal and installation

1. Disconnect the battery from ground and remove the distributor cap and gasket.

2. On some vehicles, loosen the locking screw, remove the runner, marking its orientation, and the dust cover.

3. The ignition coil is secured with screws on 2 pins. Disconnect the black/yellow wire from terminal A (+) and the white/blue wire from terminal B (-), unscrew the mounting screws and remove the coil.

4. Installation is carried out in reverse order.