Note:
- When connecting the hose to the tank, align the yellow mark on the hose with the protrusion on the tank connection area.
- When connecting the reservoir hose, align the blue mark on the hose with the protrusion on the clutch master cylinder connection area.
Note:
- When performing this procedure, refer to the image on the assembly drawing.
- Do not spill brake fluid on your vehicle; it can ruin the paint; if brake fluid gets on the paint, wash it off immediately with water.
- Clean all components in brake fluid and air dry; blow out all channels with compressed air.
- Before assembly, wipe off dust and remove foreign particles from all components.
- Replace components if directed.
- Prevent dirt and other foreign substances from entering the brake fluid.
- Do not mix brake fluid of different brands, as they may be incompatible.
- Do not reuse drained brake fluid. Use only clean DOT 3 or 4 brake fluid.
1. Pry the ring clamp off the clutch master cylinder.
2. Carefully push the piston out by applying compressed air through the clutch pipe.
3. Insert the piston assembly into the clutch master cylinder.
4. Insert the ring clamp into the groove on the clutch master cylinder.
(Information obtained from this source: www.hondabook.ru)