2. Remove the steering knuckle.
3. Place a jack under the trailing arm (A) and support it.
4. Unscrew the flange nut (B) and separate the stabilizer link (C) from the trailing arm.
5. Remove the flange bolt (D) and separate the shock absorber (E) from the trailing arm.
6. Remove the front mounting bolts (A) from the trailing arm.
7. Remove the rear mounting bolt (A) from the trailing arm.
Warning. Do not loosen the special bolts (B) on the trailing arm.
8. Lower the jack and remove the trailing arm.
9. Installation of the longitudinal arm is carried out in the reverse order of removal, taking into account the following:
- First install all suspension components and lightly tighten the bolts and nuts, then place a jack under the trailing arm and raise the suspension so that it takes the load of the vehicle, and tighten the bolts and nuts to the required torque.
- Tighten all fasteners to the specified torque.
- Before installing the wheel, clean the contact surfaces on the brake disc and on the inside of the wheel.
- Check the front wheel alignment angles and adjust if necessary.
(Original material on the website: hondabook.ru)