Shock Absorber/Spring Replacement — Installation (Honda CR-V 2)

1. Fasten the shock absorber assembly to the body. Observe the installation direction of the shock absorber base with the small dot mark facing the inside of the vehicle.



2. Fit the flange nuts (A) onto the top of the shock absorber.



3. Fit the flange bolt (A) to the bottom of the shock absorber.



4. Raise the suspension with a jack so that it takes the load under the weight of the car and tighten the nuts and bolt to the required torque.

5. Clean the contact surface of the brake disc and wheel from the inside, then install the rear wheels.

6. Check the front wheel alignment angles and adjust if necessary.