Replacing the upper control arm (Honda CR-V 2)

1. Raise the rear of the vehicle and support it securely. Remove the rear wheels.

2. Place a jack under the trailing arm and support the suspension.

3. Remove the wheel sensor wiring harness bracket (A) from the upper arm (B).



4. Remove the flange bolts (A) and remove the upper arm (B).



5. Installation of the upper arm is performed in the reverse order of removal, taking into account the following:;

• First install all suspension components and lightly tighten the bolts and nuts, then place a jack under the trailing arm and raise the suspension so that it takes the load of the vehicle, and tighten the bolts and nuts to the required torque.
• Tighten all fasteners to the specified torque.
• Before installing the wheel, clean the contact surfaces on the brake disc and on the inside of the wheel.
• Check the front wheel alignment angles and adjust if necessary.

(Original article on the website: www.hondabook.ru)