Central container
1. Remove the lower center section trim tab pins and remove the trims.
2. Unscrew the 6 screws securing the container, move the container by the top part, removing it from the latches.
3. Disconnect the wires from the lamps and remove the container.
4. Installation is carried out in reverse order.
Central floor section
1. Remove the container.
2. Unscrew the 4 screws securing the section.
3. Disconnect the wires and remove the section.
4. Installation is carried out in reverse order.
Lower instrument panel cover
1. Loosen the screw in the lower left corner of the cover.
2. Carefully lift the lid and remove it from the latches.
3. Installation is carried out in reverse order.
Driver's side switch panel
1. Pry the panel up and remove it from the latches.
2. Disconnect the wires and remove the panel.
3. Installation is carried out in reverse order.
Central section
1. Remove both steering column covers.
2. Pry and remove the section from the latches, disconnect the connector.
3. Installation is carried out in reverse order.
Glove box
1. Unscrew the 2 side screws of the limiters from inside the drawer.
2. Unscrew the drawer hinge bolts and remove the drawer.
3. Installation is carried out in reverse order.
Passenger side air vent
1. Pry up the nozzle by the right side.
2. Pry and remove the nozzle from the left curtain.
3. When installing, make sure that the curtain bushing is installed into the nozzle frame. Place the nozzle frame onto the curtain and press the right side of the nozzle until it clicks into place.
Cup holder
1. Remove the instrument panel.
2. Remove the fasteners at the base and remove the holder.
3. Installation is carried out in reverse order.
[Publication reprinted from the website «www.hondabook.ru»]