Glove box
1. Unscrew the 2 side screws securing the limiters from inside the box.
2. Unscrew the drawer hinge bolts and remove the drawer.
3. Remove the drawer bracket and buffer.
4. Installation is carried out in reverse order.
Lower cover driver side
1. Remove the container and unscrew the screws at the corners of the lid on the right.
2. Carefully push the lid towards you and remove it from the latches (the cover is secured with 3 latches at the top, one latch is provided on both sides of the steering column).
3. Disconnect the instrument lighting control.
4. Installation is carried out in reverse order.
Driver's side knee pad
1. Remove the lower instrument panel cover on the driver's side.
2. Loosen the bolts and remove the knee pad from the hinges.
3. Installation is carried out in reverse order.
Central floor section
1. Remove the left lower instrument panel cover.
2. Remove the glove box stops by unscrewing the screws.
3. Unscrew the 7 screws securing the section, disconnect the cigarette lighter connector.
4. If necessary, unscrew the 2 screws at the base of the central container and remove the container.
5. Remove the section.
6. Remove the gearshift lever handle by turning it counterclockwise.
7. Installation is carried out in reverse order.
Cup holder
1. Remove the left lower instrument panel cover.
2. Remove the center floor section.
3. Unscrew 2 screws on each side of the holder and remove the holder.
4. Installation is carried out in reverse order.
Central container
Located under the receiver, above the drink holder.
1. Remove the drink holder.
2. Unscrew the bolts from the back of the container
3. Pull the receiver towards you without disconnecting the wires, unscrew the side screws of the container and remove the container.
4. Installation is carried out in reverse order.
Receiver and heater control panel
1. Remove the left lower instrument panel cover.
2. Remove the center floor section.
3. Remove the air duct outlet window mounting bracket.
4. Disconnect the mixing flap drive cable.
5. Unscrew the side bolts on the receiver brackets.
6. Disconnect the wires from the receiver and the heater control panel.
7. Remove the lower rear bolts and remove the receiver.
8. Loosen the screws around the bracket and remove the trim panel
9. Installation is carried out in reverse order.
Instrument panel box
1. Open the cover and unscrew 4 screws.
2. Remove the staples on both sides of the casing and remove the box.
3. Installation is carried out in reverse order.
Central panel with nozzles and switches
1. Remove the decorative trim from the instrument panel.
2. Remove the instrument panel box.
3. Loosen the side screws and remove the panel, disconnect the wires if necessary.
4. Installation is carried out in reverse order.
Ventilation nozzles
The nozzles are secured with curtains at the top and latches at the bottom. Pry and remove the lower part of the nozzle from the latches, fold it up and remove it from the hooks. On some vehicles, disconnect the wiring connector and remove the nozzle.
[Material obtained from the website: hondabook.ru]