1. Thoroughly clean the disassembled parts with solvent and dry with compressed air. Do not wash rubber parts in solvent.
2. Press the intermediate shaft bearing (A) into the bearing support (B) using a special tool and a press.
3. Place the inner ring clamp into the bearing support groove.
4. Press the intermediate shaft (A) into the shaft bearing (B) using a special tool and a press.
5. Place the outer ring clamp (A) into the groove on the intermediate shaft (B).
6. Press the outer seal (A) into the bearing support (B) using a special tool and a press.
Note: Press the seal flush with the bearing support.
7. Install the retaining ring.
(Refer to the original source on the website: www.hondabook.ru)