Replacing the pressure switch in the 3rd gear clutch (Honda CR-V 2)

1. Disconnect the connector from the 3rd clutch pressure switch (A).

2. Replace the 3rd clutch pressure switch, then screw in a new one, installing a new sealing washer (B). Tighten the switch by the metal part, not the plastic part.

3. Connect the connector, making sure there is no water, oil, dust or foreign particles in it.

(Based on materials from the website: hondabook)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Mikhail Kopasov

◀ Previous

CR-V 2: Automatic gearbox

Next ▶

Replacing the pressure switch in the 2nd gear clutch
Replacing the speed sensors of the main and intermediate shafts
Replacing the solenoid valves B and C for regulating pressure in the automatic…
Testing of solenoid valves B and C for pressure regulation in automatic…
Replacing the solenoid valve A for regulating pressure in automatic…

Testing/Replacing ATF Temperature Sensor
Testing/Replacing O/D Switch
Checking the ATF fluid level
ATF fluid replacement
Transfer case