Note:
- Avoid scratching the instrument panel and adjacent components.
- The picture shows a left-hand drive model; the arrangement on the right-hand drive model is symmetrical.
1. Remove the screws from the bottom of the center section of the instrument panel (A).
2. Pull the bottom of the instrument panel center section (A) to create a gap between the instrument panel and the center section. Gently pull the section along the edge and release the clamps, then remove the section. Disconnect the connector (B) from the hazard warning switch.
3. The section is installed in the reverse order of removal. Make sure the hazard warning switch connector is connected securely.
[Information obtained from this source: HondaBook.ru]